Why choose a tool holder HYDRO SPINDLE over a classic standard tool holder with collet chuck?
1) The tolerance between the tool holder hole and the cone is +/- 0.006 (6 microns) while the average
tolerance in a classic collet chuck between the hole and the shank is +/- 0.025 (2.5 cents), so we
can say that is 4 TIMES MORE ACCURATE THAN THE CLASSIC TOOL HOLDER WITH ER32 COLLET
CHUCK
2) The HYDRO TOOL HOLDER looks like a single piece, there are no more collets and ring nuts in coupling so
the BALANCING is MUCH MORE ACCURATE because a single PIECE is balanced
3) THE TIGHTENING FORCE OF THE HYDRO SPINDLE IS TRIPLED COMPARED TO A HSKER32 WITH COLLET.
The clamping force of this HYDRO is 320 Nm, while the average clamping force of a classic collet too holder
is 120 Nm
4) The same Hydro tool holder can be used with SHANK CUTTER RH ROTATION AND SHANK CUTTER LH
ROTATION
5) TOOL LIFE INCREASED because the tool ranout decreases
6) DRASTICALLY REDUCED VIBRATIONS IN THE MACHINE
THE PERFORMANCE OF THE HYDRO TOOL HOLDER WILL AMAZE YOU COMPARED TO THE CLASSIC TOOL
HOLDER WITH COLLET ! TRY IT FOR ANY WORK ON ANY MACHINE USING HSK63F ATTACHMENT
ADVICE FOR THE RIGHT USE
- The lateral SCREW WHEAT that tightens the tool can be tightened up to the limit
- When we have to remove the shank cutter we move the screw back until the tool comes out
- If the HYDRO tool holder is not used, it must NEVER be kept under pressure without a tool inside it, therefore never pressurize the HYDRO if there is no tool stem inside
- Insert shank with tolerance H6
- Always insert clean shank inside the Hydro, without dust or residues
